Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Control before starting
For reasons of safety follow
these recommendations!
• Check the blade to ensure
that no cracks have formed
at the bottom of the teeth
or by the centre hole. The
most common reason why
cracks are formed is that
sharp corners have been
formed at the bottom of
the teeth while sharpening
or that the blade has been
used with dull teeth.
Discard a blade if cracks
are found.
• Check that the support
flange is not cracked due
to fatigue or due to being
tightened too much.
Discard the support flange
if it is cracked.
• Ensure the locking nut has
not lost its captive force.
The nut lock should have
a locking force of at least
1.5 Nm. The tightening
torque of the locking nut
should be 35-50 Nm.
• Check that the guard is
not damaged or cracked.
Replace the guard if it is
exposed to impact or is
cracked.
• Check that the trimmer
head and spray guard are
not damaged or cracked.
Replace the trimmer head
or spray guard if they are
exposed to impact or are
cracked.
• Never use the machine
without a guard or spray
guard nor with a defective
guard.
Approved accessories J-handle
Centre hole in blades Ø 25,4 mm (1")
Threaded blade axle M10
Grass blade
Plastic knives
Trimmer head
Support cup
6
– English
START AND STOP
TECHNICAL DATA
Type
Grass 255-4 1" (Ø 255 4-teeth)
Tricut Ø 300
S35
T35
Superauto II 1"
Trimmy Fix
Fixed
Cutting attachment guard Art No.
503 93 42-02
503 93 42-02
503 93 42-02
503 93 42-02
503 93 42-02
503 93 42-02
-
Publicité
Chapitres
Table des Matières
