Assembly; Assembling The J-Handle; Fitting The Suspension Ring; Assembly Of The Blade And Trimmer Head - Husqvarna J 123L Manuel D'utilisation

Assembling the J-handle

!
WARNING
Only grass blades or trimmer heads/
plastic blades may be used when the J-
handle is fitted. Clearing blades must
never be used with the J-handle.
• Clip the loop handle onto
the shaft. Note that the
loop handle must be fitted
between the arrows on the
shaft.
• Slide the spacer into the
slot in the loop handle.
• Fit the nut, bolt and knob.
Do not overtighten.
• Attach the J-handle to the
loop handle using the
three screws, as shown.
• Now adjust the trimmer to
give a comfortable
working position. Tighten
the bolt/knob.

Fitting the suspension ring

Fit the suspension ring
between the rear handle and
the loop handle. Position the
suspension ring so that the
machine is balanced and
comfortable to work with.

ASSEMBLY

Assembly of the blade and trimmer
head
It is extremely important
that the disc drive's/support
flange's guide engages
correctly in the cutting
equipment's centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
!
Fitting the combination guard, grass
blade and grass knife
• Hook the guard (A) onto
the bracket on the shaft
and secure with 1 bolt.
NOTE! Use the
recommended blade guard.
"See Technical data".
• Fit the drive disc (B) on
the output axle.
• Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D),
support cup (E) and
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
blade guard as possible.
The nut is tightened when
the spanner is turned
against the direction of
rotation (left-hand thread).
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter "Technical
data" . If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
Do not attach any blade to the unit
without proper installation of all required
parts. Failure to use the proper parts can
cause the blade to fly off and seriously
injure the operator and/or bystanders.
D
A
EN
G
F
E
B
C
5
English –