Installation Of The Pump Kit Psr - EMAK Efco Oleo-Mac 56062002 Manuel D'utilisation Et D'entretien

I
NSTALLATION OF THE PUMP KIT
A A
Figure 2 Remove the backrest
Figure 3 Remove the grid
Read and follow
install the mist blower conversion kit from
a model MB90 / AT 900 with booster
and filling pump.
See Figure 2 to remove the backrest and
access the area where the pump will be
installed.
 Move the padding and unscrew the
screws A (keeping the nut) to remove
the backrest from the chassis.
 Unscrew the three screws B in order to
remove the protective grid.
 Unscrew the red liquids tank cap;
remove the white plastic cap form the
bottom of the tank, at the center, as
shown in the box at the top left of
Figure 3.
 Disconnect the hose C from the liquid
tank enlarging the blocking ring with a
plier. Disconnect also the hose C from
the handle on the throwing pipe.
 Store the hose C.
15
Pump PSR
PSR
these steps to