Assembling Of The Pump Kit Psr - EMAK Efco Oleo-Mac 56062002 Manuel D'utilisation Et D'entretien

A
SSEMBLING OF THE PUMP KIT
After opening the box which contains the kit pump PSR, to identify the
various component parts, refer to the tables and lists of components.
E
R
S
L
N
Figure 1 Assembling of the pump PSR
 Mount the valve V on the tube P; fix the valve with the clamping hook-shaped
ring.
 Connect the hose N 770 mm long (table 198 pos.10) to the manual pump
and fix it with the clamping ring (table 198 pos. 17).
 Connect the other extremity of the hose N to the bottom connection of the tap
3-way and and fix it with the clamping ring.
Read the instructions on the next page to continue with the installation of the
pump on the mist blower.
F
V
P
M
14
PSR
To mount the pump PSR, read
the following instructions:
 Mount the group (table 198
pos. 3) of the 3-way tap S
on the pump and fix it with
the screws L.
 Connect the hose "T" F (table
196 pos. 10) to the connection
R of the pump and fix it with
the clamp (tav.196 pos. 24).
 Connect the hose E 305 mm
long (table
the 3-way tap and fix it with
the clamping ring (table.198
pos. 17).
 Mount the suction pipe by
connecting the tube P 550
mm long (table 198 pos.12)
to the manual
(table 198 pos.11), paying
attention to the direction of
the arrow (shown in the
circle) that has to be in the
opposite direction to the pipe
P. Fix the pipe P with the
clamping ring (table 198 pos.
17).
198 pos.18) to
pump M