BoomToneDJ DIGITAL TWO Mode D'emploi page 11

USING THE DIGITAL TWO
1 / Remove the packing material, and keep it.
2 / Plug the power supply adaptor into the power supply connector on the back
side of the receiver .
3 / Connect the audio connector. XLR for separate audio output, and Jack
6,35mm for unblanced mix output ( Audio A+ Audio B).
4 / Fully extend the antenna.
5 / Open the handmic battery cover and insert the 2x AA 1.5v batteries.
6 / Turn ON the receiver. The power indicator will light up.
7 / Turn ON the handmic, you need now to synchronize the hand-mic with the
receiver :
Synchronize Hand-Microphone :
- Select the desired channel on the receiver using the buttons : «UP»(4)
et «DOWN»(3).
- Press and keep pressed the button ID (2) on the receiver until this sym-
bol appears on the LCD display. You hear a «beep» sound.
- Press now quickly twice the microphone button, the «RF» symbol
starts flashing on microphone display .
Once the microphone is synchronized, the «beep» stops and the symbol «RF»
and «A» or «B» appear on receiver LCD display, it is important you keep a dis-
tance about 30cm from Handmic and receiver .
8 / Ajust now the receiver sound volume.