General Features - Idegis Domotic 2 Série Manuel D'utilisation

EN
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
Disposal of waste electrical and electronic domestic systems in the European Union
All the products marked with this symbol indicate that the product shall not be mixed or disposed with your
household waste at their end of use. It is responsibility of the user to eliminate this kind of wastes depositing
them in a recycling point adapted for the selective disposal of electrical and electronic wastes. The suitable
recycling and treatment of these wastes contributes in essential way to the preservation of the Environment
and the health of the users. For further information regarding the points of collection of this type of wastes,
please contact to the dealer where you acquired the product or to your municipal authority.
The instructions given in this manual describe the operation and maintenance of MOD. XX, MOD. XX-PH and MOD. XX-
ORP/PH electrolysis systems. For optimum performance of the salt electrolysis systems, we recommend you to follow the
instructions given below:

1 General features:

When the salt electrolysis system is installed, a quantity of salt must be dissolved into the swimming pool water. This salty water then
passes through the electrolysis cell that is located in the plant room. The salt electrolysis system consists of two elements: an
electrolysis cell and a power supply. The electrolysis cell contains a quantity of titanium plates (electrodes) and when a weak
electrical current is passed through the plates inside the electrolysis cell, there is chlorine production.
Maintaining a level of chlorine in swimming pool water keeps the water sanitised and healthy to swim in. The salt electrolysis system
will manufacture chlorine whenever the pool circulation system (pump and filter) is operational.
The power supply is provided with various safety devices, which are activated in case of irregular operation of the system, as well as a
microprocessor driven control system.
The salt electrolysis systems have an automatic cleaning system that avoids scale formation on the electrodes. Moreover, MOD. XX-
PH and MOD. XX-ORP/PH systems include a built-in pH controller and pH controller.
2 Safety warnings and recommendations:
-The equipment should be assembled and handled by truly qualified people.
-Current electrical and accident prevention regulations should be followed.
-Under no circumstances will the manufacturer be held responsible for the assembly, installation or start-up, nor any handling or
fitting of components unless they are carried out on its premises.
-The salt electrolysis systems operate at 230VAC, 50/60 Hz. Do not attempt to alter the system to operate at a different voltage.
-Check that all the electrical connectors are well tightened to avoid false contacts and their consequent overheating.
-This device is equipped with a cable that has a ground conductor. The equipment must be powered from a residual current device,
which does not exceed 30mA (RDC). The equipment must be electrically grounded.
-Before installing or replacing any component, disconnect the equipment from the mains, and use exclusively spare parts supplied by
the manufacturer.
-If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or by similar qualified personnel in
order to avoid a danger.
12