Nicols PAR COB 100 RGBW Notice D'utilisation page 9

Special construction for DMX connection
☆ At last fixture, the DMX cable has to be terminated with a terminator to reduce signal errors. Solder a 120-ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the
last fixture.
☆ If the controller is 5-pin output, it's necessary to use an adaptor to transfer signal from 5-pin output to 3-pin XLR-plug
or you can connect cables as following:
Master/Slave Operation.
The product can be linked together to work in Master/Salve mode without any console. The 1
Master and others will work as Salve unit at same effect.
Display Panel Operation
Display panel menu instruction
[MODE] menu selection or return to previous menu.
[UP] press [UP] through the menu list to increase/change the value of the current function.
[DOWN] press [DOWN] through the menu list to decrease/change the value of the current function.
[ENTER] confirm & quit out current function setting.
machine will be set as
st