Electric Connection; Operating The Device - BOMANN BQS 2244 CB Mode D'emploi

3.
NOTE:
There is a hole in the leg sections.
Check whether all leg sections are in the correct position
and that the holes are exposed.
4. With the help of the supplied nuts and bolts, fasten the
framework.
5. Insert the offset screws into the holes from the inside and
turn on the wing nuts.
6. Place the grill onto the framework and carefully push it on.
The grill can be pushed onto the framework to a depth of
about 2 cm.
7. Check that the stand is stable.
Installation
Stand or table top grill
Please refer to the illustrations.
1. Pour 1 litre of cold water into the grill pan up to the "MAX"
mark. A "MAX" mark can be found on the back section of
the grill pan.
CAUTION:
• Always grill with water to avoid overheating.
• Do not fill with water above the "MAX" mark in order
not the damage the heating element.
2. Fit the heating element with the thermostat onto the hous-
ing. Slide the thermostat from above into the recess of the
housing. Press gently until it audibly clicks into place.
3. If required, fit the windshield.
NOTE:
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
Check that the thermostat is properly fitted in the housing.

Electric Connection

1. Be sure the voltage of the device (rating plate) is in
accordance with the mains voltage.
2. Connect the mains plug to a properly installed shockproof
socket only.
Connected Load
The device is intended for a maximum power intake of
2000 W. This connected load recommends a separate input
lead secured with a 16 amp protected switch.
CAUTION: Overload!
• When using extension cords, these should have a cable
cross-section of at least 1.5 mm².
• Do not use gang plugs, because the device is too
powerful.
38
BQS2244CB_IM_new
Prior First-Time Operation
Operate the device without barbecue for 15 minutes whilst
grill pan is filled with water.
Turn the temperature control on the thermostat to the highest
position.
NOTE:
The protective foil on the heating element will be removed.
Slight formation of smoke is thereby normal. Ensure
sufficient ventilation.
Your appliance is now ready for use.

Operating the Device

CAUTION:
The appliance must always rest on a horizontal, stable, and
heat resistant surface during use.
1. Pour 1 litre of cold water into the grill pan up to the "MAX"
mark.
2. Preheat the operable device for about 5 minutes prior use.
3. Set the temperature control according to the intended use:
Low or middle settings for keeping warm or cooking,
highest setting for fast cooking or barbecuing. The indica-
tor light indicates the operation of the heating.
4. Place your grill items directly on the grid. Turn the barbe-
cue from time to time.
CAUTION:
• Check the water level!
After grilling for a long period, the water must be re-
plenished.
• First disconnect from the mains and then fill with water
up to the "MAX" mark.
• Do not pour cold water over the hot heating element. It
might get damaged.
End of Operation
Turn the temperature control anti-clockwise as far as it will go
and unplug the device.
Troubleshooting
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
If the heater cannot be switched on, check the mains outlet
and that the thermostat has been correctly fitted into the
housing.
18.10.16