Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.
The boiler must be installed by qualified personnel.
Quadra is available in the following models:
Model
Type
ie m
combined
ie FF m
combined
The boiler must be installed in compliance with local
laws and regulations.
Before installing, please bear in mind that:
- the boiler must not be located over a cooker or other
cooking equipment
- minimum clearances for maintenance work must be
respected
- it is forbidden to leave flammable products in the room
where the boiler is installed
- heat sensitive walls (e.g. wooden walls) must be
protected with appropriate insulating material
The boiler is supplied standard with a support plate.
Install as follows:
- prop the boiler supporting plate (F) against the wall
and check that it is perfectly horizontal using an air
level
- mark 4 holes (6-mm diam.) to fix boiler support plate
(F)
- check all measures are correct, and drill the wall by
above-mentioned drill diameter
- hook boiler to support plate.
Make hydraulic connections.
2.
HYDRAUILC CONNECTIONS
Position and dimensions of hydraulic connections are
specified in figure 1:
A - CH delivery
B - DHW outlet
C - Gas connection
D - DHW inlet
E - CH return
BOILER INSTALLATION
Category
Power rating
B
24-28kW
11BS
C
24-28kW
3/4"
1/2"
3/4"
1/2"
3/4"
INSTALLER'S MANUAL
support plate
Fig. 1
400 (24 ie m)
450 (28 ie m)
Quadra ie FF m
400 (24 ie FF m)
450 (28 ie FF m)
Fig. 2
4
D
C
B
A
Quadra ie m
203.5
123.5
50
145
123.5
50
328
E
328
Publicité
Table des Matières
