Desontter CVI II Guide De Démarrage Rapide page 7

legend
1 Fieldbus connector
● Remove the cover
Carefully drive the module into its
location.
Slide it softly along the board located
below.
● Tighten the 2 screws by using a T8 Torx
screwdriver.
● Power on the controller.
02/2016
1
CVI3 range
● Power off the controller.
● Locate the Fieldbus connector at the bottom
panel (see picture below). The cover is
protected by a grey cover.
legend
1 Fieldbus connector
● Remove the cover
● Carefully drive the Fielbus module into its
location.
● Tighten the 2 screws by using a T9 Torx
screwdriver.
● Power on the controller.
6159931440
Issue no: 03
Series: -
7 / 36