Beginning Recordings Using The Indoor Climate Software; Online Measurement; Starting The Recording At A Preset Starting Time - Wohler LOG 220 Mode D'emploi

Data recording
4.2

Beginning recordings using the indoor climate software

4.2.1

Online measurement

Fig. 16: Beginning online measurement
4.2.2 Starting the recording
at a preset starting time
Fig. 17: Wöhler indoor climate
software – time setting for when
data recording is to start automati-
cally
26

Perform the steps described in chapter 4.1.
When taking online measurements the measure-
ment values are transferred immediately from the
data logger to the PC.
In the main screen of the software, click "Online
measurement"

Enter the desired measurement interval.

To start recording, select the "Online meas-
urement" check box to activate the recording.

To stop recording, clear the "Online meas-
urement" check box to deactivate the record-
ing.

Perform the steps described in chapter 4.1.

Select Start logging > Time.

Enter the time when recording should start
and the logging rate.
The program calculates the stop time automatical-
ly. Recording stops when the data memory is full.

Click Save to save the setting.
You can now disconnect the data logger from the
PC. The data logger will begin recording automat-
ically at the set time.
NOTE!
Data recordings are not shown in the data logger
display when the device is set to logging mode.
During the recording process the REC LED flash-
es when recording a new value.