Troubleshooting; Technical Specifications - ECG XMS 144 U Mode D'emploi

TROUBLESHOOTING

Before bringing the device to the repair centre, please check the following table.
Symptom
No power
• The power supply is not properly connected to the socket.
Sound
• Audio cables are not connected properly.
No sound or • The volume is set to min.
distorted sound. • The sound is muted.
Cannot play disk
• The disk is inserted improperly.
• The parent lock classification coded on the disk is higher
than the parent lock level set on the device.
• The disk is not compatible with this device.
• The disk is contaminated.
After connecting • The connected USB device most likely is not a certified type.
a USB device,
the device stops
working
The buttons on the • The device is experiencing interference caused by static
device do not work electricity etc.
The remote • There are no batteries in the remote controller.
controller does not
• The batteries are dead.
work • The remote controller is not directed at the remote
controller sensor.
• The remote controller is outside of its operating range.
• The device is turned off.

TECHNICAL SPECIFICATIONS

Tuner
CD
INPUTS
Amplifier
Remote controller
Main unit dimensions (w × h × d)
Speaker dimensions (w × h × d)
Net weight
Gross weight
Power
Power input
Standby power input
Operating conditions
Cause
FM band range
Number of FM station pre-sets
Frequency characteristic
S/N ratio (filter A)
Dynamic range
Distortion and noise
Fluctuation
Supported CD files
USB
Supported USB files
Maximum size of USB device
LINE-IN
Power output (max.)
Frequency characteristic
Battery
Temperature
Relative humidity
Correction
• Check the proper connection of the power supply.
• Connect the audio cables properly.
• Increase the volume.
• Press MUTE on the controller to activate the sound.
• Press PLAY/PAUSE.
• Make sure the disk is inserted with the label facing upward.
• Change the parent lock settings.
• Clean the disk
• The device does not play uncertified USB devices. In case the
player stops working, turn it off, unplug the power cord from the
socket and remove the USB device. Plug the power cord back in.
The device should work normally.
• Turn the device off and unplug from the socket. Plug the power
cord back in and turn on the device.
• Insert AAA/1.5 V battery.
• Replace the batteries with a new set.
• Make sure the remote controller is directed at the remote
controller sensor.
• Make sure the remote controller is close enough to the device.
• Turn the device off and unplug from the socket. Turn the device
back on.
87,5 ~ 108 MHz
30
20 Hz ~ 20 kHz
>80 dB (1 kHz)
≥70 dB (1 kHz)
≤-60 dB (1 kHz)
Under measurable level
CD-R, CD-RW
1.1, 5 V 500 mA
MP3, WMA
16 Gb
3.5 mm jack
2× 2.5 W
±3 dB (20 Hz ~ 20 kHz)
1 × AAA
140 × 210 × 140
120 × 130 × 140
2
3.2
AC ~100–240 V, 50/60 Hz
20 W
<0.5 W
-10 °C ~ +35 °C
5 % ~ 90 %
GB
43