Connection; Using The Remote Controller; Inserting The Batteries - ECG XMS 144 U Mode D'emploi

CONNECTION

Speaker output
Connect the speakers to the relevant speaker terminals using the
supplied speaker cables.
LINE IN
This device is equipped with an input which can be used to lead an
analog stereo audio signal to the device from external systems, such as
VCD or CD players, video cameras or MP3 players etc.
Using an audio cable, connect the terminals of the external player to the
LINE IN input of this device.
You can listen to music from the connected external source by pressing
the SOURCE on the device or remote controller.
GB

Using the remote controller

Insert batteries into the remote controller. Direct the controller towards the remote controller sensor on the
head panel. The remote controller operates with a reach of 8 metres under a maximum angle of 30 degrees
horizontally.

Inserting the batteries

1. Remove the cover
of the battery
compartment on the
back side of the remote
controller.
Note:
• If you do not plan to use the remote controller for a longer period of time, take the batteries out.
• Do not combine old and new batteries or different types of batteries.
• Dead batteries can leak and damage the remote controller.
• Do not expose batteries to excessive heat, e.g. direct sunlight, fire etc.
• Be considerate towards the environment and dispose of old batteries according to local valid regulations.
40
2. Insert AAA/1.5 V battery into the battery
compartment. Make sure the battery
polarity correct, marked + and - on the
inside of the battery compartment with
symbols.
Speakers
Speakers output
3. Return the cover to its
place.