myaudioart MA3 Mode D'emploi page 46

Application:
Master Stereo + Output Mono: Standard configuration – the Link output can be
used to connect an active subwoofer using a mono jack cable.
Master Left / Master Right + Output Right/Output Left: This configuration serves
to connect two systems in order to create a cliché-stereo system that consists of a left
and a right loudspeaker. Here, the "Master" is the control unit and the signal source is
connected to it. The second system must be configured to "Slave" in this case.
Master Mono + Output Mono: This configuration serves to use the system in
portrait orientation and optimum sound. Audio playback is adjusted to the vertical
alignment of the speakers and the Link output can be used to connect an active
subwoofer using a mono jack cable.
Adjusting input sensitivity
If you use one of the two audio inputs INPUT (stereo jack connector), it might be
necessary to adjust the system's input sensitivity. Adjustment is required when the
input level is too high, causing the system to overmodulate (the LED POWER lights
up orange).
0,2 V / 2 V
0.2 V: Setting for portable devices such as mp3 players, smart phones, tablets, etc.
2 V: Setting for stationary devices such as TVs, CD players, tuner, computer, etc.
46
User Manual