myaudioart MA3 Mode D'emploi page 45

Connecting two MA 3 systems with a link cable
There is also the option of connecting two MA 3 systems via a 3.5 mm jack cable to
enjoy a wider stereo sound.
– Remove the fabric covering and the fleece (see page 47)
– Remove the four screws of the acryl cover
– Take off the cover
– Adjust the switch inside the system as required (Master / Slave)
– Connect the two systems
It is imperative that the MA 3 connected to the audio source is set to "Master" and that
the second MA 3 is set to "Slave" so that it can be operated via the "Master"-MA 3.
When operating the system with the remote, this can also only be done via the
"Master" system.
DIP
Switch 1 Switch 2
OFF
ON
OFF
ON
OFF
DIP switch 3 has currently no function.
User Manual
DIP DIP
Switch 4
OFF ON
OFF ON
ON ON
ON ON
OFF OFF
Sound module LINK connector
MASTER STEREO AUSGANG MONO
MASTER LEFT AUSGANG RIGHT
MASTER RIGHT
MASTER MONO AUSGANG MONO
SLAVE
AUSGANG LEFT
INPUT
45