3. Description of the Variable Road Speed Limit Function
3.1 Switching On the Variable Road Speed Limit Function
•
Accelerate to the desired speed.
•
Push the selector switch towards the descibed position (see ta-
ble, page 24) and release.
Pedal Interface II stores the current speed and limits the engine prefor-
mance. The stored speed can not be overridden.
Depending on the engine performance, the vehicle's
weight and on downhill roads, overriding the desired
speed may be possible.
3.2 Increasing or Reducing the Speed Limit
By holding the control switch towards the described position (see table,
page 24), the speed will also be pemanently increased or decreased un-
til the selector switch is released. The current speed at the time of the
release is stored as the new speed limit.
3.3 Increasing or Reducing the Desired Speed by 1 km/h
(Tip-up/ Tip-down Function).
Briefly tip the selector switch toward the described position (see table,
page 24) and release. This procedure can be repeated as desired..
3.4 Switching Off the Variable Road Speed Limit Function
(Off Funktion)
Push the selector switch toward the described position (see table, page
24) and release.
22