myPool pH Manuel D'installation page 6

MyPool | pH · ORP
5. SETUP INSTRUCTIONS MYPOOL SYSTEM
1
Set Point adjustment
Press the button for 3 seconds, use
Stand-by
Press and buttons simultaneously for 5 seconds to switch off the unit backlight. Dosage and calibration
are disabled. To exit standby, press
Priming
While the pump is in stand-by press down
View Level
pH/ORP
measure
Alarm list
1. LEV
2. WDG
3. OFA1 & OFA2
4. Stand By
5. Flow
0000138876
2 3 4 5
and
6
and to set the desired value.
buttons simultaneously.
and in the same time.
°
rev. 1.3 EN
1) Button to increase the value
2) Button to decrease the value
3) Button Menu/Esc
4) Button Cal/OK
5) Button to set the setpoint
6) Digital display
Show temperature
measure if PT100
sensor is installed
4