Warnings And Safety Precautions - Sadelta SPS-2530D Manuel De L'utilisateur

Warnings and safety precautions

Always consult a qualified person for service or repair.
Do not dismantle, modify or manipulate the interior of the Power Supply,
it can produce severe electrical discharge and may invalidate your warranty.
Always use the on/off power switch on the Power Supply, do not use
the mains plug to turn the Power Supply on or off.
Be careful not to the damage the power cable
Do not touch this unit with wet hands or bare feet.
Always install the Power Supply on a stable surface, in a dry and well
ventilated area.
Do not cover or obstruct with the cooling fan on the back of the Power
Supply.
The power supply has an exit with DC protection, its function is to protect
from short circuit. If a short circuit occurs at the DC output, immediately turn
off the switch power of the Power Supply and repair the cause that produces
the short circuit.
This Power Supply incorporates a current limiting system which will protect
the unit form overloading.
Even if the chassis of the power supply is grounded. Use correct terminals
to connect the cable. It is imperative that your electrical system counts
with a proper grounding for the network connection. In opposite case
or of doubt do not use this gadget.
Do not use this Power Supply for devices that require high current input
at the start e.g. motorized equipment.
Do not use this Power Supply to charge a car battery.
Before replacing the fuse of the Power Supply, make sure that
the PowerSupply is off and disconnected from the mains power and substitute
it foranother fuse of the same type.
Always connect the Power Supply to a 220V AC grounded wall plug
15
EN