Reflecta Visilux Studio Kit 130 Mode D'emploi page 3

Synchronization
- Test button: For testing, or multiple flashes can be used.
- Sync socket: The standard 0.35 cm jack type socket on the rear panel of the unit may be used for direct
connection to a camera set to "x" synchronization. A "Radio remote control receiver" may also be
plugged into this socket.
- Photocell: The unit has a built-in photocell, enabling the unit to be triggered by the flash from any
other flash unit, or a small camera mounted flashgun. The photocell is mounted behind the red
"Ready" indicator on the rear panel.
-
Modeling lamp control
Set the yellow switch to "
Fuse
The modeling and flash circuitry is protected by a single 7 amp fuse mounted on the rear panel. Never replace the
fuse with one of a different rating. Be sure to switch OFF the unit before changing the bulb or fuse.
Warning - high voltage
Do not touch the flashtube assembly for thirty minutes after disconnecting from the supply.
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders
and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products should not
be mixed with general household waste. There is a separate collections system for these products.
" to turn on the modeling lamp and keep it on all the time.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3