SEVERIN BR-7962 Mode D'emploi page 10

into its storage, press the foot switch of
the retract mechanism.
Accessories
The accessories can be stored in the
accessories holder, which attaches to the
tube
Multi-purpose tool
The multi-purpose tool is especially suitable
for cleaning large areas.
Upholstery tool
The upholstery tool is suitable for cleaning
smaller areas such as arm rests and chair
seats etc.
Upholstery brush attachment
This brush attachment can be fitted to the
upholstery tool by sliding it on sideways.
This brush tool is suitable for cleaning
uneven areas such as upholstered surfaces,
picture frames, rows of books etc.
Crevice tool
The crevice tool is designed to clean difficult-
to-reach areas such as grooves, niches,
corners and crevices.
Models with parquet-brush
The parquet brush is used for high-grade
hard floors such as laminate floors, parquet
or ceramic tiles.
Changing dust bag or filters
●
Before any filter is changed, always
switch the appliance off and remove the
plug from the wall socket.
The vacuum cleaner uses replaceable filters.
When replacing the motor or exhaust-air
filter, it may be necessary to cut the filters to
size with a pair of scissors.
The indicator shows when the dust bag
needs changing: as soon as it is permanently
illuminated, the dust bag has reached its
capacity. The appliance must be switched off
before the bag is replaced.
A noticeable decrease in vacuuming power
also indicates that the dust bag has reached
its capacity.
Changing the dust bag
- Remove the hose from the unit by
pressing the two buttons at the end of the
hose.
- Press the filter compartment release and
open the compartment.
- Flip the filter holder upwards.
- Pull the full dust bag from the filter
holder.
- Fit the cardboard frame of the new dust
bag into the filter holder.
- Push the filter holder back into the filter
compartment.
- Close the cover of the filter compartment
by pressing down lightly until it is heard
locking into place.
Changing the motor-protection filter
The motor-protection filter is located at the
rear of the filter compartment. Should the
filter be visibly dirty, replacement is
recommended at the same time as the dust
bag is changed.
- Lift out the motor-protection filter
holder from the filter compartment.
- Remove the old motor-protection filter
from its holding bracket.
- Insert a new motor-protection filter into
the bracket.
- Push the motor-protection filter holder
back into the filter compartment.
Changing the exhaust-air filter
The exhaust-air filter is located in the
exhaust-air filter compartment. Should the
filter be visibly dirty, replacement is
recommended.
- Press the release button to open the
exhaust-air filter compartment.
- Remove the cover and lift out the
exhaust-air filter holder.
- Change the exhaust-air filter. Ensure that
the smoother surface of the filter is facing
the motor.
- Replace the filter holder into the filter
10