Installing And Operating Your Fridge - Singer NEIGE-297-NF-WH Manuel D'utilisation

BEFORE USING THE APPLIANCE

Installing and operating your fridge

Before starting to use your fridge, you should pay attention to
the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• We do not take the responsibility for damage that may
occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed
to direct sunlight.
• Your appliance should be at least 50 cm away from stoves,
Gas ovens and heater cores, and should be at least 5 cm
away from electrical ovens.
• Your fridge should never be used outdoors or left under
the rain.
• When your fridge is placed next to a deep freezer, there
should be at least 2 cm between them to prevent humidity
on the outer surface.
• Do not place anything on your fridge, and install your fridge
in a suitable place so that at least 15 cm is available on the
upper side.
• The adjustable front legs should be adjusted to make sure
your appliance is level and stable. You can adjust the legs
by turning them clockwise (or in the opposite direction).
This should be done before placing food in the fridge.
• Before using your fridge, wipe all inside surfaces and
drawers with warm water added with a tea spoonful of
sodium bicarbonate, and then rinse with clean water and
dry. Put all the parts back into the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes
at the rear) by turning it 90° as shown in the figure to
prevent the condenser from touching the wall.
• Refrigerator should be placed against a wall with a free
distance not exceeding 75 mm.
EN
49