Cleaning And Maintenance - Beurer BARBERS CORNER HR 5000 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Cutting hair without the comb attachment
If you want to cut your hair very short (0.5 mm to 2.5 mm), you can use the
device without a comb attachment.
• If a comb attachment is attached to the device, pull the comb attach-
ment upwards off the device.
• To set the precision adjustment level, use the dial for precision adjustment
on the rear of the device. You can now set the desired cutting length to
between 0.5 and 2.5 mm.
• Start the application.
Thinning hair
The device has a thinning function. The thinning function can be used
to reduce the volume of hair as only some of the hair is gathered
and cut.
• In order to use the thinning function, slide the sliding switch for the
thinning function on the front of the device to the left.
Cutting precise contours (e.g. sideburns or neck hair)
You can also use the device to cut particularly precise contours, such as sideburns or neck hair.
• If a comb attachment is attached to the device, pull the comb attachment upwards off the device.
• Turn the device so that the front side of the device is facing your head.
• Move the device slowly from the top downwards.

9. Cleaning and maintenance

Cleaning the device
WARNING
• Always pull the mains adapter out of the socket before cleaning the device. Risk of electric shock!
• Only clean the housing of the device with a soft cloth dampened with warm water or the clean-
ing brush supplied.
• Do not clean the device with highly flammable liquids. Risk of fire!
• Do not clean the device in the dishwasher!
• Clean the stainless steel blade after each use to prevent lots of hair getting jammed inside it,
which could otherwise impede flawless operation.
26

Publicité

Table des Matières
loading

Table des Matières