Cleaning And Storage - Dörr FSE-1N Notice D'utilisation

06 | INSTALLATION OF RECEIVER AND SENDER
Receiver
Connect the fl ash cable (1) to the corresponding socket of your studio fl ash. If necessary, use the supplied 3,5 mm
adapter.
Insert the AC power cord (2) into the power cord connection of your studio fl ash. Insert the power cord of your
studio fl ash into the power cord connection (3) of the receiver.
Sender
Slide the hot shoe of the sender (7) onto the hot shoe of your camera.
If necessary, use the supplied sync cord.
CAUTION:
07 | OPERATION
1. Switch on the connected studio fl ash and set it to the desired power level.
2. When the receiver is connected correctly, the green LED indicator (5) lights up constantly.
To check the radio connection, press the test button (9) at the sender.
When the receiver is connected properly the studio fl ash is triggered once.
The receivers LED indicator (6) lights up briefl y in red colour.
3. Turn your camera on and set the desired aperture, exposure time and ISO number.
Please ensure that the exposure time is not shorter than 1/250s, and not shorter than the cameras fl ash sync
time (fl ash sync time, refer to the specifi cations of your camera). It is recommended to use an exposure time
of 1/125s.
4. When you take a picture now, the connected studio fl ash will be triggered at the same time.
Only model FSE-4N (4 channels):
Changing the channels
In case of interfering frequencies from the environment, it is recommended to set a di erent channel at the sen-
ders channel setting (11). There are 4 channels available. The receiver automatically switches to the new channel
when you press the reset button (4).
08 |

CLEANING AND STORAGE

Never use aggressive cleansing agents or benzine to clean the device. We recommend a soft, slightly damp
microfi ber cloth to clean the outer parts of the device. Make sure to take the device o power before cleaning!
Store the device in a dust-free, dry and cool place. This device is not a toy - keep it out of reach of children. Keep
away from pets.
09 | SPECIFICATIONS
Sync speed
Triggering delay
Radio frequency/range
Camera connection
Studio fl ash connection
Power source sender
Power source receiver
Dimensions sender
Dimensions receiver
Weight sender (with battery)
Weight receiver
Your camera must be o power.
> 1/250 s
approx. 1/600 s
315 MHz/approx. 15 m
Hot shoe or sync cord
Jack plug 6,35 mm/adapter 3,5 mm included
1x 23A 12V battery (pre-installed)
Lifetime approx. 1200 hours
AC 100~240V /50-60Hz
approx. 65 x 45 x 35mm
approx. 72x 45 x 25 mm
approx. 35 g
approx. 98 g
9