Metabo DKG 80/16 Notice D'utilisation Originale page 15

actuated if the trigger and trigger safety lock are in
initial position.
Contact actuation: For every fastening operation,
the trigger (9) and trigger safety lock (3) must be
actuated, whereby the order of actuation is not
defined. For subsequent fastening operations, it is
sufficient either if the trigger remains actuated and
the trigger safety lock is actuated, or vice versa.
Finishing nails that can be used:
N = Type
Typ
N = Length
L
N = Wire thickness
T
Staples than can be used:
K = Type
Typ
K = Back width
B
K = Length
L
K = Wire thickness
T
A = Dimensions:
Length x Width x Height
m = Weight (without fasteners)
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
Using these values, you can estimate the
emissions from this tool and compare these with the
values emitted by other tools. The actual values
may be higher or lower, depending on the particular
application and the condition of the tool or mounted
tool. In estimating the values, you should also
include work breaks and periods of low use. Based
on the estimated emission values, specify protec-
tive measures for the user - for example, any organ-
isational steps that must be put in place.
Vibration (weighted effective value of acceleration;
EN 28662-1, ISO 8662-11) :
a = Vibration emission level
h
K = Measurement uncertainty (vibration)
h
Sound level (EN 12549):
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Measurement uncertainty
pA WA
Wear ear protectors!
ENGLISH en
15