Hkoenig V28 Manuel D'utilisation page 7

- Store the appliance in a dry place
CLEAN THE BOILER AT REGULAR INTERVALS
Release the residual steam in the boiler when you use up. Cut down the power, after the appliance
refrigeration enough put up one side of the cleaning valve(10), turn the cleaning valve(10)(do not
lie flat the appliance when you open the cleaning valve, otherwise the water will leakage).Then fill
appropriate water into boiler, insert the boiler cleaning brush and turn the cleaning brush to clean
the boiler, then waggle the equipment softly and pour-out the water. Repetition clean 2-3 times,
then assemble the cleaning valve back and screw it tightly.
SUGGESTIONS
- Divide the washing according to the correct ironing temperatures. Start by ironing those garments
that require a lower temperature. For fuller details, refer to the chart at end of this booklet.
- Fabrics such as velvet and wool, and accessories such as gloves, handbags, etc. will regain their
brand-new look and texture by simply passing the iron near the surface of the fabric and pressing
the steam button.
- Imprints left in carpets by furniture can be removed by applying steam on the parts where the pile
is crushed and the brushing lightly.
If the carpet is made of synthetic material, do not select a high
temperature.
How to get a professional ironing finish
A normal iron generates only a small quantity of steam. In this case it is necessary to products
steam constantly in order to eliminate crease in the fabric being ironed.
A professional ironing system works rather differently. The fabric is first made damp by the
steam and then, in a second phase, dry-ironed in the normal way. This means that every.
Tiniest crease is removed and your garments are ironed to perfection.
In the first phase (steam-damping of the fabric),hold the iron about 20 cm above the fabric and
press the steam(2). Pass the iron over the garment in a circular movement so that the powerful
jet of steam damps the fabric. Lightly creased garments require only a few moments of
steaming. While very heavy fabrics or garments with particularly difficult creases must be
damper, so steam must be applied for a few seconds more.
During the second phase (dry ironing), check that the thermostat knob is in the correct position
for the type of fabrics; release the steam button(2) and dry-iron the garment. The special
ironing plate will prevent the fabrics from becoming shiny. Using this ironing technique, and
following the suggestions in the chart below, you will find it easy to give your garments a really
professional ironing finish.