Battery Test - Casanoov TOUCH Mode D'emploi

[Tapez ici]

7. Battery test

The voltage level of the battery can be tested as follow：
a. Enter programming => one long beep follow to confirm
b. Press(89) end up with (#). => Battery is OK, then would have a long beep to indicate.
=> Battery is low, then would have short beep and the red LED indicator flashes to indicate
c. Keypad exits programming mode
Note! This programming is without long/short sound confirmation. For this operation, The long beep is used
for indicating the battery is ok and the short beep is used for indicating the battery is low.
8. Delete the users' pin code
8.
If you forget the multiple pin codes that programmed previously. You can enter into programming mode and
delete all users'pin code for the security.
Steps：
a. Enter programming => one long beep follow to confirm
b. Press(00) end up with (# ) => one long beep and one short beep follow to confirm
c. Now the users' pin code for each channel is factory default setting, other programmed pin codes are deleted.
d. Keypad exits programming mode
9. Learning signal from transmitter
User can directly enter learning mode to learn the signal from transmitters as follow:
a. Enter programming => one long beep follow to confirm
b. Press ( 59 ) end up with ( # ), enter learning mode => one short beep follow to confirm
c. Enter 2 digits of the channel's number which you would like to learn the signal from transmitter. (Example as
01
is for 1 channel), end up with ( # ). =>after one long beep, green LED indicator lights on.
st
d. Now the keypad is ready to learn the signal from transmitter. You have to press the transmitter for
programming the signal to keypad within 10 seconds, then the green LED indicator will go off with one long
beep to finish the process.
EN
6