Entering Programming Mode - Casanoov TOUCH Mode D'emploi

[Tapez ici]
EN
Operation Instruction
-- When keypad enters programming mode, if the keypad does not receive the further command within 6s,
keypad would exit programming mode automatically.
-- When misoperating the keypad during programming, you can enter programming mode again after keypad
exits programming mode automatically.
-- When received the command "*"or "#", keypad would receive the command then judge the command is
correct or not. If it is incorrect command, keypad would exit programming mode; or it is correct command,
keypad would operate further.
-- When programming, if user key in users' pin code more than 4 digits, the keypad would recognize it as
incorrect operation, then exit programming mode.
-- When keypad in working mode, if the interval time between inputting each digit is more than 6s, keypad
would ignore the previous digit.
--if keypad is not learning any code, the red LED indicator would flash 5 times
***If there is no any operation in 20s, keypad would enter standby mode. If user need to operate keypad
when it is in standby mode, then must press any button on keypad to make it back to working mode.

1. Entering programming mode

To enter programming mode, key in the 4 digits installer's pin code and end up with "*" key.
Note! The factory default installer's pin code is 0 0 0 0
0+0+0+0+* => one long beep will follow to confirm.
Note: Blue LED lights on when entering programming, and it goes off when exit programming
3