Troubleshooting; Technical Data - DS Produkte SC3108 Mode D'emploi

4. Allow everything to dry completely before assembling the device again.
5. Place the half with the blades on top of the attachment and push the catch up.
It must engage audibly.
Trimmer
1. Pull the attachment for the hair trimmer off by pressing it carefully up.
2. Carefully clean the hair trimmer and the attachment under running water.
3. Allow everything to dry completely before assembling the device again.
Manicure/pedicure attachment
1. Remove the attachment by sliding your fi ngernail gently below the attachment
and pressing it carefully up.
2. Clean the nail attachment under running water.
3. Only clean the fi ling and grinding attachments with a dry cloth or a soft brush.
4. Allow everything to dry completely before assembling the device again.
• Insert the batteries again.
• Store the device at a location that is not accessible for children and pets and
that is protected from the sun and damp.

Troubleshooting

Problem
The device does not re-
spond.
The manicure / pedi-
cure attachment does
not move.

Technical Data

Article number:
Model number:
Voltage supply:
Possible cause/solution
Is the on/off switch in position 1 ?
Are the batteries inserted correctly? Pay attention to
the polarity (see the "Inserting / Changing Batteries"
section).
Are the batteries too weak? If necessary, change the
batteries (see the "Inserting / Changing Batteries" sec-
tion).
Is the fi ling or grinding attachment in the correct posi-
tion? (see the "Use" chapter)
Z 07482
SC3108
2 x 1.5 V batteries, AAA type
19