Technical Details; Caring For The Environment - BIELMEIER BHG 280 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

DISMANtLING AND ASSEMBLY

DISMANtLING

1 Front cover (5): Press on the top right and left-

hand corners of the cover (5) to release the

locking mechanism . Then slide up the cover

(5) to remove .

2 Prefilter (7): Open the catches in the direction

shown in Fig. 4 to remove the prefilter (7) .

3 Main filter (8): Grasp the two straps at the top

to pull out the filter (8) .

4 UV tubes (9): Carefully rotate the tubes (9)

either clockwise or anticlockwise until the

connections can be seen through the open-

ings of the holders . Now remove the tubes (9)

from their holders . Only grasp the tubes (9)

by the ceramic endpieces and wear gloves to

do so .

Fig. 4: Dismantling

Fig. 5: Assembly

ASSEMBLY

1 UV tubes (9): Carefully fit the tubes (9) into

their holders . Gently rotate the tubes (9) either

clockwise or anticlockwise until the connec-

tions audibly engage . Only grasp the tubes (9)

by the ceramic endpieces and wear gloves to

do so .

2 Main filter (8): First position the main filter (8)

at the bottom of the housing and then press

into the housing . The word "HEPA" (on white

side of filter) must face outwards .

3 Prefilter (7): Insert the filter (7) and turn the

catches in the direction shown in Fig. 5 to

secure the prefilter (7) .

4 Front cover (5): First position the bottom

holders in the openings of the housing . Secure

the cover (5) by pressing on the top right and

left-hand corners (5) until the cover audibly

engages .

tROUBLESHOOtING

Problem

Reason

Appliance is not functioning

Power plug is not

properly inserted in socket .

Front cover is not secured .

No power supply from socket .

Appliance does not respond

Batteries are failing .

to remote control unit

Batteries without contact .

Appliance is running but not

Objects are blocking

emitting air

air supply or exhaust;

protective foil has not been

removed .

Expected air purification

Appliance is standing in a

effect is absent

room with poor ventilation or

is blocked by other objects .

Filters are contaminated with

smoke and dust .

The air quality indicator

Sensors in appliance are

shows air quality constantly

contaminated .

worsening while the per-

formance level of the air

purifier keeps increasing

If the solutions suggested here still do not eliminate the problem, please contact Bielmeier Hausgeräte

GmbH or your nearest service centre .

Never try to repair the air purifier yourself!