Kenmore KKTK1.7S Guide D'utilisation Et D'entretien page 3

OPERATING YOUR ELECTRIC KETTLE
INITIAL USE
Before rst use, run the kettle through several cleaning cycles following the instructions below to
remove factory material or dust from the interior. Discard the water from these cleaning cycles.
CAUTION
The lled water level must be between the Max and Min level as indicated on
the housing. Too little water will do damage to the heat element. Water over ll
may cause boiling water to over ow out of the kettle.
OPERATION
1. Raise Lid by pressing down on Latch Button in
top of Lid (Fig. 2). Pour water into kettle to
desired level and close Lid. Ensure that Lid Latch
on kettle interior is not obstructed and that Lid
completely closes.
2. Place kettle on Power Base (Fig. 3). Position
kettle so that spout faces away from you.
3. Plug kettle into a power outlet. The Control
Panel Display will light up green for a few
seconds to indicate electrical connection and
then dim to gray until the next press of a button.
The Display defaults to the Heat Water icon [
and 212°F (Fig. 4). Pressing the Function Button
[ ] will display the Keep Warm icon [
default temperature of 190°F (Fig. 5). Another
press displays the Boil Extend icon [
default time of 3 seconds (Fig. 6). Press the
Power button to immediately begin heating to
those default levels.
4. To adjust the Heat Water, Keep Warm and Boil
Extend settings, press the Down or Up buttons
when the function is selected in the display. Boil
Extend adjustment is only available for 212°F
Heat Water.
NOTE
Heat Water and Keep Warm adjust in 10°F
increments to a minimum of 110°F. Boil Extend
adjusts in 1 second increments to a maximum of
6 seconds.
Fig. 2
]
] and
] and
Fig. 4
down
function
4
OPERATING YOUR ELECTRIC KETTLE
OPERATION (cont.)
5. When the settings are as desired, press the
Power button to start heating. The Heat Water
icon will start blinking, indicating that heating is
underway. Once water reaches the temperature
setting, the blinking Keep Warm icon will appear
in the display, indicating the temperature at
which the water will be kept. If the Heat Water
setting is 212°F, the display will pass to the
blinking Boil Extend icon before it passes to the
Keep Warm icon.
NOTE
The Boil Extend function is for operation at high
altitude locations, where water can begin to boil
before it reaches the normal boiling tempera-
ture of 212°F. The extra 3 to 6 seconds that can
be added to heating are so that water may heat
to 212°F before the unit switches to Keep Warm.
6. When it is raised from the Power Base the
kettle shuts o and all setting adjustments are
canceled. The kettle reverts to the default
settings once it is placed back onto the Power
Fig. 3
Base.
CAUTION
Be very careful when pouring water from kettle as boiling water can scald you. Also to avoid
scalding, do not open the kettle lid while the water in the kettle is hot.
EMPTY-STOP-OFF FUNCTION
The kettle will turn o automatically if it boils empty. If this occurs, unplug the kettle and wait for
it to cool down before using it again.
up
power
Fig. 5
down
function
Fig. 6
down
function
5
up
power
up
power