Connection And Operation - Toxic TXA-400 Mode D'emploi

CONNECTION AND OPERATION

A) POWER INPUT TERMINAL (CONNECTING THE POWER Fig. 1)
CAUTION:
AS A PRECAUTION, IT IS ADVISABLE TO DISCONNECT THE
VEHICLE'S BATTERY BEFORE MAKING CONNECTION TO THE +12
VOLT SUPPLY WIRING.
4/8 GAUGE wire is recommended for both the power and ground wires. 12
Gauge, for the remote turn-on wire. Both types are available at most Mobile
Audio Dealers or Installation Shops.
(1) Ground: To Vehicle's Chassis
To avoid unwanted ignition noise caused by ground loops, it is essne-
tial that the Amplifier is grounded to a clean, bare, metal surface of the
vehicle's Chassis.
NOTE:
GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN (1 METER).
(2) +12 Volt(fused) Constant Power: To Battery (+)
Due to the power requirements of the Amplifier, this connection should be
made directly to the positive (+) terminal of battery. For safety measures,
install all in-line Fuse Holder (not supplied) as close as possible to the
battery positive (+) terminal with an ampere rating, not to exceed total value
of fuses in AMP.
(3) Remote Turn-on Input: To Power Antenna output of Car Stereo
This Amplifier is turned "ON" remotely when the vehicle's stereo is turned
"ON".
Page 12
© TOXIC 2007