Kicker SOLO-BARIC L7 Manuel D'utilisation page 2

Authorized KICKER Dealer:
Purchase Date:
Enclosure Model Number:
Enclosure Serial Number:
IMPORTANT SAFETY WARNING
Prolonged continuous operation of an amplifi er, speaker, or subwoofer in a distorted, clipped or over-
powered manner can cause your audio system to overheat, possibly catching fi re and resulting in serious
damage to your components and/or vehicle. Amplifi ers require up to 4 inches (10cm) open ventilation.
Subwoofers should be mounted with at least 1 inch (2.5cm) clearance between the front of the speaker and
any surface.
CHECK THE LOAD
The Solo-Baric L7 subwoofer enclosures are internally wired for a 2 ohm load at the speaker-wire
connection terminal. Check to see if your amplifi er is optimized to drive this load.
SOLO-BARIC L7 ENCLOSURES
The Solo-Baric-series enclosures combine
KICKER's award-winning line of subwoofers
with computer-modeled and human fi ne-
tuned enclosures to offer a level of bass
performance never before thought possible
from a commercially available, ready-to-install
subwoofer system. The VL7S12 enclosure
features a 12 inch Solo-Baric L7 subwoofer,
the TL7S10 enclosure features a 10 inch
Solo-Baric L7 Subwoofer, and the DL7S12
enclosure features two 12 inch Solo-Baric L7
subwoofers.
Plug your subwoofer speaker wire into
the terminals using the red connector as
positive and the black connector as negative.
Connect the other end of the wire to your
subwoofer amplifi er in accordance with its
owner's manual.
Sound Check: Poor bass response? Check the system phasing by reversing the positive and negative
speaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase in
reference to the rest of the audio system.
Pro Tip: With a KICKER IQ amplifi er, a pair of KICKER QS speakers, and a few KICKER cables, you're
looking at a full system upgrade that will dominate! KICKER amplifi ers and accessories make it easy to
upgrade with your existing or stock source unit. Ask your dealer about KICKER amplifi ers and speaker
upgrades to complete your system!
Note: The use of a subsonic fi lter will signifi cantly increase power handling. The power handling specifi cation in this chart
is calculated using a 25Hz, 24dB/octave subsonic fi lter.
2
2017 L7S Enclosure Rev C.indd 2 2017 L7S Enclosure Rev C.indd 2
SOLO-BARIC L7 SUBWOOFER
ENCLOSURE OWNER'S MANUAL
Models: DL7S12 / VL7S12 / TL7S10
10/27/2016 10:49:28 AM 10/27/2016 10:49:28 AM