Product Use - Greencut CBT400L Manuel D'utilisation

TECHNICAL DATA
Model
Input
Output
Compatible Battery Pack
NOTE: GREENCUT reserves the right to modify the specifications of the device
without prior notice.
LED FUNCTIONS
MODE
Stabdby power
Charging
Full Charge
Too hot too cold
Defective

PRODUCT USE

CHARGING THE BATTERY PACK
Battery packs are shipped in a low charge condition to prevent possible problems. Therefore, you
should charge them until the green LED on the front of the charger comes on.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the batteries in the battery pack will become hot. You should
let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.
NOTE: Refer to CHARGING A COOL BATTERY PACK for normal recharging of
batteries.
CHARGER
CBT400L
100-240V / 50-60Hz AC
40V 1,8A
BT402L (BAT-40V-2A) - BT404L (BAT-40V-4A)
RED
OFF
OFF
OFF
Flash
Flash
31
GREEN
ON
Flash
ON
Flash
OFF
EN