1.
LED display:
Adjusting range from 1.0 - 6.0 (1/32 to Full) for Flash and modeling lamp.
2.
Modeling Lamp indicator:
When pressing the Modeling Lamp switch: The upper indicator is on means modeling lamp can
adjust synchronously. If the lower indicator illumines the modeling lamp can be adjusted
independently. When both indicators are off, modeling lamp will be switched off.
3.
Modeling lamp adjusting key:
It can adjust the output power of the modeling lamp by upper and lower key.
4.
Buzz Sound switch:
When Buzz indicator is switched on, the buzz will sound during charging and stops with sound
when flash is fully charged. The modeling lamp is on during flash time. When buzz indicator is
switched off and no sound during charging appears, please press the modeling lamp selection
key. The modeling lamp now is off during flash time, but after the flash is charged, the modeling
light switches on.
5.
Test button:
Flash light can be fired by press the TEST button.
6.
Flash Power adjusting key:
This key can adjust the flash output from high to low or low to high.
7.
CELL-Slave mode selection key:
This key has five different types of Slave sync mode (1 to 5 positions):
(1)
Normal sync mode (when flash light flash, synchro can make another light flash at once)
(2)
0.5S delay sync mode (Synchro do not trigger during the first flash, the second time flash
will trigger and flash synchronously after 0.5 Sec)
(3)
Twice trigger delay sync mode (Synchro do not trigger during the first flash, the second
time flash will trigger and flash synchronously)
(4)
Thrice trigger delay sync mode ( Synchro do not trigger during the first and second flash,
the third time flash will trigger and flash synchronously)
(5)
Quartic trigger delay sync mode (Synchro do not trigger during the first, second and third
flash, the fourth time flash will trigger and flash synchronously)
reflecta gmbh, Junghansring 60, D-72108 Rottenburg-Ergenzingen
Phone: +49 7457 9465-60 – Fax: +49 7457 9465-72 –
mail@reflecta.de
–
www.reflecta.de