Inventum MC 60 Mode D'emploi page 38

You have the best equipment with the MC 60 instrument and the
MCA 60 professional set attachments. This can otherwise be offered
only by a professional chiropodist.
General
• This instrument is intended only for the treatment of hands
(manicure) and feet (pedicure).
• Select an attachment and push it onto the instrument spindle using
a slight pressure. The attachments can be heard to engage. To
remove: pull the attachment and instrument apart in the axial
direction (straight).
• Switch on the instrument by sliding the slide switch to the left
(anticlockwise running) or to the right (clockwise running). The two
buttons marked with plus (+) and minus (-) allow you to select the
speed of rotation. Start every application at low speed and increase
it only as required.
• All file and cutting attachments are coated with a sapphire grain.
This guarantees extremely long life and almost guarantees freedom
from wear.
• Do not exert heavy pressure and always guide the attachments
carefully over the surface to be treated.
• Move the instrument under light pressure in circular movements
slowly over the parts to be treated.
• Note that the cutting attachments will have a reduced effect if the
skin is softened or moist. For this reason, do not carry out any
pretreatment in a bath.
• Do not remove all the callus skin in order to retain the natural
protection of the skin.
• Always ensure that the spindle can rotate freely. It must never be
38