TallyGenicom 7265 Manuel D'utilisation page 18

Paper handling
90
Online Tractor1
Load Online
1 2 3 4
Setup
16
Open the coloured latch lever of the right-hand tractor and
align it to the paper width.
Insert the fanfold paper into the right-hand tractor.
Make sure that it is inserted by the same length as on the left-
hand tractor in order to avoid any paper jam.
Close the tractor flap and lock the tractor by turning the trac-
tor lever to the rear.
Do not tighten the paper excessively to avoid tear-
ing the perforation holes; do not allow excessive
slack or the paper will not remain flat enough to en-
sure accurate feeding.
Be sure to align the paper stack in parallel with the printer
and that the paper flow is unobstructed.
Re-install the bottom cover.
Lower the front cover.
Switch the printer on. The active paper source (Traktor1) appears in the dis-
play. The paper is automatically loaded when the printer is in online mode
and receives data from the computer.
Press the Load (4) key to load paper before starting the printout.
Quick start-up