Trouble Shooting - Fagor PLATINO Manuel D'utilisation

Trouble Shooting

PROBLEM
Machine does not operate
Machine jams/ clogs or
stops operating
Squeaking noise when
juicing
Leaking from underneath
the Bowl
Strainer Damage
Too much pulp coming out
Bowl is stuck and will not
detach from the Base
Food Chute/Lid is stuck
The Bowl shakes
The Food Chute, Bowl,
Strainer, Rotating Basket
and silicone parts get
stained.
There is no juice pouring
out of the Bowl.
Slow Juicer Platino Manual.FINAL.indd Sec2:12 Slow Juicer Platino Manual.FINAL.indd Sec2:12
SOLUTION
• Check power cord and power source.
• Check that all parts have been assembled
correctly.
• Check Food Chute is clear and is not
blocked.
• Check that hard seeds have been removed
before juicing and are not stuck in the
machine.
• Turn machine off, and switch to reverse for 3
seconds. Switch back on to continue juicing.
Repeat this process if necessary.
• Disassemble upper section and clear
remaining pulp.
• Squeaking sound is perfectly normal. Please
remember not to run the Platino without any
food.
• Be sure the silicone pad is tightly in place
after cleaning.
• Refer to operation instruction for proper
usage and juicing tips. Remember not to over
stuff food or force food in the Platino.
• Cut food into smaller pieces, especially
fibrous foods, to avoid fibers scrapping
around the Auger. Insert food at a slower
pace and allow all food pulp to eject from the
unit before adding more.
• This is commonly caused by excess food in
the Bowl. Switch to reverse for 3-5 seconds.
Repeat process 2-3 times. Then, pull the
Bowl upward while turning.
• Switch to reverse for 3-5 seconds. Repeat
process 2-3 times, you can then press down
on the Food Chute while turning.
• It's normal for the Bowl to shake when juicing
or operating the Platino in reverse.
• Vegetables like kale, collards, carrots and
spinach contain beta carotene, which is
responsible for the discoloration.
• Clean all parts of the upper unit immediately
after use.
• Open the drip stopper.
12
6/17/13 8:03 PM 6/17/13 8:03 PM