ThermoPro TP-21 Manuel D'utilisation page 6

displayed) the display will turn to 0:00, the unit beeps and
"▼▲" will blink for 60 seconds.
EN
Count up
1. Press MODE to select timer mode. The upper display
will show a small TIMER and 0:00.
2. Press START/STOP button to start count up. The "▲
will blink for every second.
3. To stop the count up process, press START/STOP button.
The "▲ becomes solid. "
4. Press CLEAR button to clear the setting back to 0:00.
Helpful Hints
Do not allow the probe or probe wire to come into contact
with flames. If cooking with grill cover closed, only use
medium or low heat.
If the probe becomes defective within 90 days warranty
period, please return defective probe to address below
along with return address and we will send you a new
probe no charge.
If the temperature displayed seems to be reading too
high or the temperature seems to increase too quickly,
check to make sure the probe tip is not poking through
the food. Reposition the probe tip into the center of the
thickest part of food. Avoid touching bone or heavy fat
areas.
Caution:
Always wear a heat resistant glove to touch the stainless
steel probe sensor or wire during or just after cooking.
Do not touch with bare hands.
Keep the stainless steel probe sensor and wire away
from children.
Not Intended for Use by Persons aged 12 and Under
Clean the stainless steel probe and dry thoroughly after
each and every use.
-10-
Do not use the receiver or transmitter in the rain. They
are not waterproof.
Do not expose the plug of the stainless steel probe or
the plug in hole of the transmitter to water or any liquid.
This will result in a bad connection and faulty
readings.
"
Do not expose the receiver or transmitter to direct heat
or surface.
Do not use stainless steel probe in microwave oven.
Cleaning
Clean the stainless steel probe and dry thoroughly after
each and every use.
Keep the stainless steel probe sensor and wire away
from children.
Wash the metal probe tip with hot soapy water and dry
thoroughly. Do not immerse the probe in water while
cleaning.
Wipe the transmitter and receiver with damp cloth. Do
not immerse either in water.
FCC Compliance
Information to user
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the users' authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
-11-
EN