Programme Selection And Special Functions; Important - Candy CDPM 65750 Mode D'emploi

PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
•
"U WASH" button
This button allows you to modify the wash
intensity, according to how dirty your dishes
are, by modifying
temperature.
Press the button to increase the intensity of
wash cycle ( indicator light) or to reduce
the intensity of wash, this also allows you to
decrease the wash length time (
light).
The combination of the button with the 4
main wash programmes enables to have 8
additional wash cycles (achieving a total of
12 programmes of washing).

IMPORTANT

When the dishwasher is switched on,
the setting last used will be indicated.
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button
display will show two lines.
Choose a programme by pressing the
"PROGRAMME SELECTION" button.
If you wish, press the "U WASH" button.
If you wish to select an option, press the
corresponding button (the indicator light
will turn on).
The option buttons can be selected or
deselected WHITIN one minute of the
programme commencing.
Press the "START" button.
The length of the program will be shown on
the display alternating
minutes [I.e: 1 h (1 hour) / 25 (25 minutes)].
the wash time and
indicator
. The
•
hours with
When the door is shut, after an audible
signal has sounded, the programme will
start automatically. The display will show
the time remaining to the end of the cycle.
WITHIN one minute of the programme
commencing, another programme
can be selected, simply by pressing
the "PROGRAMME
button (it is also possible to change
•
the "U WASH" button setting ).
"IMPULSE" programmes
The "IMPULSE" programmes use an
impluse washing technology, which reduces
consumption,
performances.
IMPORTANT
The "intermittent" working of the
washing pump
considered a malfunction, it is a
characteristic of the impulse washing
so must be considered a normal
function of the programme.
Programme interruption
Opening the door when a programme is
running is not recommended especially during
the main wash and final hot rinse phases.
However, if the door is opened while a
programme is running (for example, to add
dishes) the machine stops automatically and
the display will flash the remaining time
before the end of the cycle. Close the door,
without pressing any buttons. The cycle will
start from where it left off.
IMPORTANT
A running program can be interrupted
without opening
pressing the "ON/OFF" button. In
this case, simply press the "ON/OFF"
button again to restart the cycle from
where it left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
14
SELECTION"
noise and increases
MUST NOT
the door
BE
by