Offset Adjustment; Technical Data - HYDAC ELECTRONIC ZBE I2-000 Notice D'utilisation

ZBE I2-000

5.6 Offset adjustment

Depending on the existing lead length between the current measurement adapter
ZBE I2-000 and the connected HMG, there may occur offset errors due to physical
influences.
In order to eliminate offset errors and to optimise the measuring accuracy, we recommend
to carry out an offset adjustment at the used measuring channel prior to each measurement.
6

Technical Data

Input data
Measuring range
Max. measurement voltage
Frequency range
Electrical connection
Internal overload protection
Output data
Output signal
Accuracy
Ambient conditions
Operating temperature range
Storage temperature range
Relative humidity
CE-Mark
Protection class acc. DIN EN 60529
Other data
Voltage supply
Weight
Edition: 2018-01-05
Detailed information on the offset adjustment can
be taken from the corresponding user manual of
the used HMG or CMU 1000.
±5 A AC/DC
48 V AC/DC
(internal galvanic separation to the output)
≤ 10 kHz without PWM filter
≤ 10 Hz with PWM filter
2 Standard built-in sockets, 4 mm
(banana sockets)
Thermal, release current approx. ±6 A,
self-resetting
HSI (HYDAC Sensor Interface)
Automatic sensor detection
≤ ±0.5 % FS (room temperature)
≤ ±1.0 % FS (entire temperature range)
0 .. +50°C
-20 .. +60 °C
0 .. 70 %, non-condensing
EN 61000-6-2; EN 61000-6-4
IP 40
Via HYDAC measuring devices HMG 5x0, HMG 2500,
HMG 30x0; HMG 4000 or CMU 1000
~ 140 g
HYDAC ELECTRONIC GMBH
9
Part No: 670002 D/E/F