Tristar BL-4430 Manuel D'utilisation page 7

Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz.
Always place the unit on a flat stable surface and ensure at least 10 cm. free space around the
unit. This device is not suitable for outdoor installation or use.
Before First use
Wash before using the device for the first time the cap for refill hole(no. 1), the jar lid (no. 2)
and the transparant jug (no. 3) in a warm soapy water. Rinse and dry thoroughly. These parts
are not dishwasher proof.
Caution! Never immerse the base (no. 6) in water or other liquid. Run the blender no longer
than 5 minutes continuous, after that always cool the mixer for 15 minutes.
Use
Before placing the transparent jar (no.3) on the base (no.6), make sure the plug is not placed
in the socket and the position of the speed selector (no. 5) on the 0 mode is selected.
Cleaning and maintenance
Always remove the plug from the outlet before storage or cleaning the device
Clean the outside of the device with a clean soft, damp cloth. Never immerse the device in
water or any other liquid.
Clean the cap for refillhole (no. 1), the jar lid (no. 2) and the transparant jug (no. 3) in a warm
soapy water. Rinse and dry thoroughly. These parts are not dishwasher proof.
CAUTION! The blades in the jar are very sharp, never try to replace them and be
careful with the cleaning. Avoid any contact with the blades, they can seriously
injure.
Place the ingredients in the jar. The maximum capacity of the jar
is 1,5 liters. To select slow mode 1, for faster mode 2, mode 0
for release. For a short fast operation, select the Pulse mode,
you should switch insisting in this mode, use up to 1 minutes,
about possible overheating of the engine. Allow the unit to cool
before further use.
7
UK