Battery Operation Mode; Mains Operation Made; Troubleshooting - REV JY-168 Instructions De Montage Et D'utilisation

Battery operation mode

Open the battery compartment
driver. Insert a 9V block battery whilst observing the polarity.
When not in use for a long period, you should remove the
batteries.

Mains operation made

Plug the connector of the mains power unit into the connection
(7/14)
socket . Afterwards, connect the mains power unit to the
230V mains.

Troubleshooting

Error
No function
No transmission
Disturbed
transmission
13
(8/15)
Possible causes
- Check power supply
- Is the mains adapter correctly connected?
- Are the batteries correctly inserted?
- Do the batteries have sufficient voltage?
- Reduce the distance of the transmitter from
the baby by observing the minimum
distance of 1m or increase the response
sensitivity
- Reduce the distance of the receiver from
the transmitter. Check the position of the
channel selection switch. Both must be in
the same position.
- Transmitter must be located near the baby
- Are both devices switched on?
- Select a different channel
- Reduce the distance of the receiver from
the transmitter.
- Check the accumulators/batteries and if
necessary replace them.
- Reduce the distance of the receiver from
the transmitter.
with the help of a screw