Welltime 45691640 Instructions D'installation page 13

Proper use
The sink tap is only for installation on sinks.
This product is suitable for instantaneous water heaters (flow heaters) and boilers. It is not
suitable for low pressure water heaters such as wood or coal burning bath geysers, oil or
gas bath geysers, open electrically heated water tanks. Any use other than that described
here or modification to the product is not permitted and may lead to damage to persons or
property. There is also the risk of injury and loss of life. The product is intended for personal
use only and not for medical or commercial use.
Safety notes
– Only allow experts carry out the installation work.
– CAUTION DAMAGE BY WATER!
Prior to installation please turn the general water supply off.
– Ensure that all gaskets have the correct fit.
– These taps are not suitable for use on low pressure and small electrical storage heaters.
– We recommend the installation of a filter into the appliance or at least the use of angle
valves with filter, in order to avoid the inflow of foreign matter, which could damage the
cartridge.
– This tap is only intended for use in private households! Only suitable for use in rooms with
a temperature over 0 °C, when there is danger of frost, sut off the water supply and empty
the tap.
– CAUTION! Take care when adjusting the warm water. Danger of scalding!
– Incorrectly installed fittings can cause water damages!
– Please ensure that no caustic or corrosive products such as detergents or household clea-
ning products make contact with the connection hoses; this can lead to water damages.
– Despite careful production, sharp edges can occur. Please exercise caution!
– Please flush the tap through with hot water for two to three minutes after installation,
especially before using the tap for the first time.
IMPORTANT: PLEASE KEEP THIS DOCUMENT
FOR LATER REFERENCE! READ CAREFULLY!
13