Publicité
Les langues disponibles
Les langues disponibles
Dehumax helps in preventing from moisture damage where books or valuables are stored, in
basements, etc.
Starting the Dehumax
Before plugging the device on mains
power, check that the Dehumax is turned off.
•
Place the humidifier on the floor.
•
Plug the power cord to the mains power
and turn the device on.
The Dehumax dehumidifier is now ready
•
to use.
•
When first using the dehumidifier, operate
the unit continuously for 24 hours.
•
Check whether the filter is in place. Never
use the device without filter.
Control panel
Ion operation on
High fan
Timer on/off
indicator light
indicator light
indicator light
7
6
5
Operating instructions
•
Press POWER
appliance. The LED
when Dehumax is on. The POWER pad
blinks 5 times per second when a humidity
or
temperature
occurs.
•
The humidity level can be set with
humidity control pads
digital display
set within a range of 35% RH (relative
humidity) to 85% RH in 5% increments.
•
Press ② to select the desired operation
mode
from
Continuous dehumidifying and Hygro
Smart
function dehumidifying.
©
Control panel description
•
The digital panel shows the set humidity
level while setting.
•
Then it shows the actual room humidity
level.
Hygro Smart
on indocator ight
Continuous
Dryer operation
operation on
on indicator light
indicator light
Bucket full
indicator light
8
4
3
2
①
to turn on and off the
⑧
remains green
sensor
malfunction
③
and
⑧
. The humidity can be
Dehumidifying,
⑧
•
Error codes displayed:
- E1: humidity sensor error. Unplug the unit
and plug it back in. If the error persists,
contact after sales service.
- E2: temperature sensor error. Unplug the
unit and plug it back in. If the error persists,
contact after sales service.
- P1: unit is defrosting. Allow time for the
unit to automatically defrost. The error will
clear after the unit self-defrosts.
- P2: the tank is full or not in the right
position. Empty the tank and/or replace it
in the right position.
function
©
- E3: Unit malfunction - Unplug the unit and
Unit operation on
plug it back in. If the error persists, contact
indicator light
after sales service.
Note: when more than one error occurs, the
error display order is: P2-E2-E1-P1-E3
Main functions
1
•
Dryer mode
The unit can make the MAX dehumidification
function when it is under the Dryer mode.
The fan speed is fixed at high fan speed. The
humidity level is automatically controlled
according to the actual room humidity.The
unit will quit dryer mode after a maximum 10
hours' operation.
Note : The Dryer mode must be operated in a
close room,do not open the door and window.
④
and
To make the best effective dehumidification,
please first dehydrate the wet clothes. Make
sure to direct airflow at the wet clothes. For
thick and heavy wet clothes may not get the
best effective dehumidification.
Dryer,
Caution : Do not cover the air outlet of the unit
with clothes. It may cause excessive heat, fire
or failure of unit. Do not place the wet clothes
on the top of the unit and do not make the
water drop into the unit. It may cause electric
shock,creepage or failure of unit.
10
Publicité
