Dmx 512 Communication; Single Plp-Rem Unit - Spectravision PLP-REM Mode D'emploi

DMX 512 communication

Single PLP-REM unit

1) Make sure DIP switch 1 is switched OFF.
2) Make sure the lights are turned ON with the remote first.
Address dial
Address dial setup
Setting the DMX address of the PLP-REM:
Select the desired number on the address dial. The chosen number deter-
mines the DMX addresses of the PLP-REM & lamps.
Each lamp uses 3 bytes of DMX data (R-G-B), and all lamps receive the same
DMX data from the PLP-REM.
Address dial
0
position
R G
DMX
1 2
address
The DMX start address can be overruled by using the RS-485 command:
"set DMX start address" (see page 15)
12
12VAC
1
B R G B R
3 4 5 6 7
DMX PANEL
230VAC
2 ...
G B ...
8 9 ...
Connect DMX
panel
to DMX IN (+/-)