Publicité
8 von 61
Preparing the plinth
A
Level the plinth on the floor.
A
Mark the hole positions.
A
Drill the following holes in the marked positions.
- APCL007, APCL011 (47 cm plinth): 12 mm in diameter, depth of approx. 65 mm.
- APCL020 (75 cm plinth): 16 mm in diameter, depth of approx. 120 mm.
A
Insert the plugs in the holes.
A
If a tumble dryer is to be fitted to the plinth, use 2 6 x 12 screws to attach each of the clamping plates to the rear of
the plinth, see Fig. 1.
A
Line the plinth up with the underlay supplied (2), see Fig. 2.
A
Fasten the plinth to the floor with the hexagonal-head wood screws (3) and the B13 washers (4), see Fig. 2.
Fitting a washing machine to the plinth
A
Remove the machine feet.
A
Fit two M10 nuts on each M10 threaded pin and counter them such that 15 mm ± 1 mm of thread protrudes, see
Fig. 3.
A
Instead of fitting the machine feet, screw in the M10 threaded pins with the 15 mm long side as far as they will go
and tighten, see Fig. 3.
A
Fit a B10.5 washer on each threaded pin.
A
Lift the washing machine onto the plinth and insert the threaded pins into the plinth.
A
From the inside of the plinth, fit a B10.5 washer and an M10 nut on each threaded pin and screw tight, see Fig. 3.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 4.
Fitting the plinth panels
A
Use 4 M4 x 25 screws to attach each of the 2 side panels, see Fig. 5.
A
Use 4 M4 x 25 screws to attach the front panel, see Fig. 5.
en
16.07.2020
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11313371
Publicité
