Accessories - Bird Control Group Handheld 200 Mode D'emploi

beam angle with respect to the horizon. If the angle
of the laser projection exceeds the set angle, the laser
will switch off automatically and the user receives
haptic and visual feedback.
Set the appropriate mode according to the local
terrain. Set a mode above zero degrees for increasing
terrain levels (figure 8.1), set the zero (0) mode for flat
terrain (figure 8.2) or set a mode below zero degrees
for decreasing terrain levels (figure 8.3).
The 'OFF' mode deactivates the Horizon
System and allows the user to project the laser beam
in any direction.

6. Accessories

Battery charger
Use the included battery charger to recharge the
batteries.
1. Plug one end of the power cable or car charger
adapter to the charger's power input. Plug the other
end of the cord into a wall outlet or the cigarette
lighter socket in your vehicle. All yellow status
indicators (Z in figure 6.1) blink once as the charger
runs a quick self-test.
2. Insert the batteries in the charger slots and make
sure the positive battery pole corresponds with the
(+) symbol on the charger (figure 6.1). Make sure
that solid contact is made between battery poles
and metal contact points. Once inserted, the yellow
status indicators (Z in figure 6.1) start blinking.
+10 +20
This indicates that the batteries are charging.
+5 +30
0 OFF
Charging is completed when all status indicators
-5 -30
-10 -20
are continuously illuminated. It takes 2 to 3 hours to
fully charge a set of two empty Handheld batteries.
The charger individually monitors the charging status
of each battery and will stop charging when the
+10 +20
+5 +30
batteries are fully charged. To ensure safe operation,
0 OFF
-5 -30
the battery charger is equipped with overcharge
-10 -20 -10 -20
protection and reverse polarity protection. If a battery
is inserted in reverse or if a defective battery is
inserted, all three yellow status indicators will keep
blinking.
+10 +20
+5 +30
CAUTION:
0 OFF
-5 -30
-10 -20
• Non-rechargeable batteries cannot be charged with
this battery charger.
• Use a power source corresponding to the voltage
specified on the nameplate of the charger.
Safety • Do not charge the battery in presence of flammable
®
liquids or gases.
• Do not expose charger to moisture, water, rain, snow
or spray.
• Never carry the charger by the power cord or yank it
to disconnect from socket.
• After charging or before attempting any
maintenance or cleaning, unplug the charger from
the power source. Pull by plug rather than cord
whenever disconnecting the charger.
• Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
User manual Handheld 200|500 HSS
EN
NL
FR
DE
ES
PT
IT
9