LENCO SCD-651 Mode D'emploi page 4

9. WARNING! NEVER INSERT AN OBJECT INTO THE PRODUCT THROUGH THE VENTS OR
OPENINGS. HIGH VOLTAGE FLOWS THROUGH THE PRODUCT AND INSERTING AN OBJECT
CAN CAUSE ELECTRIC SHOCK AND/OR SHORT CIRCUIT INTERNAL PARTS. FOR THE SAME
REASON, DO NOT SPILL WATER OR LIQUID ON THE PRODUCT.
10. Do NOT use in wet or moist areas such as bathrooms, steamy kitchens or near swimming pools.
11. Do not use this device when condensation may occur.
12. Although this device is manufactured with the utmost care and checked several times before leaving
the factory, it is still possible that problems may occur, as with all electrical appliances. If you notice
smoke, an excessive build-up of heat or any other unexpected phenomena, you should disconnect
the plug from the main power socket immediately.
13. This device must be well ventilated at all times!
14. This device must operate on a power source as specified on the specification label. If you are not
sure of the type of power supply used in your home, consult your dealer or local power company.
15. The socket outlet must be installed near the equipment and must be easily accessible.
16. Do not overload AC outlets or extension cords. Overloading can cause fire or electric shocks.
17. Devices with Class 1 construction should be connected to a main socket outlet with a protective
earthed connection.
18. Devices with Class 2 construction do not require an earthed connection.
19. Keep away from rodents. Rodents enjoy biting on power cords.
20. Always hold the plug when pulling it out of the main supply socket. Do not pull the power cord. This
can cause a short circuit.
21. Avoid placing the device on any surfaces that may be subject to vibrations or shocks.
22. To clean the device, use a soft dry cloth. Do NOT use solvents or petrol based fluids. To remove
severe stains, you may use a damp cloth with dilute detergent.
23. The supplier is not responsible for damage or lost data caused by malfunction, misuse, modification
of the device or battery replacement.
24. Do not interrupt the connection when the device is formatting or transferring files. Otherwise, data
may be corrupted or lost.
25. The USB memory stick should be plugged into the unit directly. Don't use a USB extension cable
because it can cause interference resulting in a failure of data transfer.
26. The apparatus shall not be exposed to dripping or splashing and make sure that no objects filled with
liquids, such as vases, shall be placed on or near the apparatus.
27. To completely disconnect the power input, the mains plug of the apparatus shall be disconnected
from the mains, as the disconnect device is the mains plug of this apparatus.
28. The mains plug of the apparatus should not be obstructed OR should be easily accessible during its
intended use.
29. The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
30. A minimum distance of 10 cm around the apparatus is needed for sufficient ventilation.
31. The ventilation should not be impeded by covering the ventilation openings with items such as
newspapers, table-cloths, curtains etc.
32. No naked flame sources such as lighted candles should be placed on the apparatus.
33. Attention should be drawn to the environmental aspects of battery disposal.
34. The apparatus can only be used in moderate climates, extremely cold and warm environments
should be avoided.
4