• No technical alterations may be made to the
product.
Swing assembly
1. Select a level and clean surface with enough
room to assemble the swing.
2. Lay the nest swing (1) out on the floor.
3. Guide the four side reinforcements (2) through
the straps on the edge of the nest swing.
When inserting the side reinforcements, make
sure one thin end points to one thick end.
4. Push the four side reinforcements together. The
drill holes of each pair of side reinforcements
must overlap precisely (figure B).
5. Loosen the pre-assembled nuts on the moun-
ting brackets (3) and remove them as well as
one washer.
6. Put a hook with the remaining washer through
a drill hole from above.
7. Put the second washer on from underneath.
8. Secure the hook with a nut (figure C).
Attach the swing only to fittings that you can
guarantee with absolute certainty to be of suffi-
cient strength. For assembly use standard com-
mercial swing hooks with a minimum thickness of
10 mm and with a safety feature to prevent them
from inadvertently coming loose. With wooden
beams the attachment must go right through
the wood and be locked from above to ensure
sufficiently secure connection.
Different attachment hooks
Only mount the swing on suitable mounts.
These are:
No. 1: closed mounting hooks that are fastened
to the swing elements with a carabiner hook
(figure D).
No. 2: standard commercial swing hooks with a
safety feature to prevent them from inadvertently
coming loose (figure E).
Note! The eye on the mounting eye
(1) must be attached transverse to the
swing direction so that the attachment
element of the swing is not damaged
too badly during use.
10
GB/IE
Setting the height of the
swing element
The height of the seat can be set using the ring
on the upper end of the swing. Once you have
set the length of the rope it will tighten itself
when load is placed on the swing (figure F). Set
the length on both sides in such a way that the
swing is absolutely horizontal.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature.
Clean only with water and wipe dry afterwards
with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the packa-
ging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which
is meant to reflect the recycling cycle – and a
number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
With regard to complaints, please contact the
following service hotline or contact us by e-mail.