Publicité
Les langues disponibles
Les langues disponibles
Before plugging the appliance into the socket, check the
following:
• Make sure your hands are dry.
• The socket must have an earth connection.
• The socket must be able to withstand the machine's
maximum power output as indicated on the data plate (see
Description of the tumble dryer).
• The power supply voltage must fall within the values
indicated on the data plate (see Description of the tumble
dryer).
• The socket must be compatible with the dryer's plug.
Should this not be the case, replace the plug or the
socket.
!
Do not use extension cords.
!
The dryer must not be installed outdoors, even if the
space is sheltered. It can be very dangerous if exposed
to rain or storms.
!
Once installed, the dryer's electrical wire and plug must
be within reach.
!
The power cord must not be bent or squashed.
!
If the plug being replaced is a non-rewirable type, then
the cut-off plug must be disposed of safely. DO NOT
leave it where it can be inserted into a socket and create
a shock hazard.
!
The power cord should be checked periodically and
replaced by a cord specially prepared for this dryer and
fitted only by authorized technicians (see Service). New or
longer power cords are supplied at an extra charge by
authorized dealers.
!
The manufacturer denies any responsibility should any
of these rules not be followed.
!
If in doubt about any of the above consult a
qualified electrician.
The tumble dryer should be installed level in order to
operate correctly.
After installing the tumble
dryer in its permanent
position, make sure it is
level; check its side-to-side
levelling first, followed by
front-to-back.
If the tumble dryer is not
perfectly level, use a wooden
block to support it while you
adjust the two front feet, up
or down as necessary.
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.
Publicité
